User manual

Computer Remote Control
E-2 ProMaster 2500 User Manual
Handler Computer Remote Control
This section lists commands that specifically affect the device handling
functions of the 2500. It includes the following information:
•
Handler Remote Command Set
— Lists the available handler CRC
commands. A command summary, which lists commands,
descriptions, and the 2500’s response, precedes the complete list.
•
Handler Remote Error Codes
— Lists the handler error codes that
may be returned while the 2500 is being operated in computer remote
mode.
System Setup
The 2500 handler and labeler controllers receive CRC commands and
send responses to the host computer through the RS-232C port labeled
“Remote RS232” on the back of the 2500. This is the only port that will
respond to the handler or labeler CRC commands listed in this section.
To ensure correct operation of the Remote port with the host computer,
set the parameters for the Remote port according to the host computer
requirements.
Note: The default baud rate for computer remote mode is 9600.