User manual

ProMaster 2500 User Manual B-1
B
Firmware Keys and STOP
Commands
The ProMaster 2500 is normally operated in remote mode using the
TaskLink software. Some of the firmware key commands listed in this
Appendix are active only while the handler is in local mode. To execute a
firmware key command from one of the handler menus, perform the
following steps:
1. Put the handler into local mode by pressing the
LOWER CASE
+
L
keys.
2. Go to the appropriate menu and press the key sequence to access the
display.
3. Enter the new numeric value or answer the prompt from the 2500’s
keyboard and press
START
.
The 2500 supports a second set of commands known as STOP commands,
because the commands are entered after pressing
STOP
to pause the
2500. These differ from the firmware key commands because they can be
used while processing devices so you do not have to exit the current Task.