User manual

Repair and Replacement Procedures
7-66 ProMaster 2500 User Manual
ProMaster 2500 Thermal Printer Standard Spares Kit
(Part Number: 952-0156-002)
Description Part Number Quantity
Air cylinder, shutter/thermal 298-5500-901 1
Air cylinder, programming module site clamp 287-5500-902 1
Ball bearing, high/low valve 280-0180-901 1
Bearing, 3/8” i.d., 1/2” o.d., 1/2” t. 280-0200-901 1
Bearing, 3/8” i.d., 9/16” o.d., .14” t. 280-0038-902 2
Bushing, beam 608-0014-001 2
Cable, print head to board, 2500T 709-0418-001 1
Cam track 636-0056-001 1
Cheat-key switch 371-3099-003 1
Chip, stepper drive 317-3770-001 2
Clutch, 24V 277-3310-901 1
Clutch, w/48 tooth pulley 277-3318-901 1
Cup, vacuum tip, new molded (L, B, G) 604-1483-001 2
Drive roller assembly 615-1628-001 1
Driver 800-0008-001 1
Emitter optic assembly, high power 815-2070-001 1
Fuse, pico, stepper drivers 416-3050-002 4
Gasket, beam manifold 608-0015-001 1
Gasket, vacuum filter 608-0011-001 1
Harness assembly, 2500 beam 709-0392-001 1
Linear bearing, .636 i.d., .875 o.d., .625 t. 280-0038-901 2
Motor, rotate/orbit 815-2055-001 1
O-ring, .114” i.d. x .07” xsect 249-0018-901 1
O-ring, .176” i.d. x .07” xsect 249-0316-901 1
O-ring, .239” i.d. x .07” xsect 249-0014-901 1
O-ring, .364” i.d. x .07” xsect 249-3816-901 2
O-ring, .489” i.d. x .07” xsect 249-0113-901 1
O-ring, .864” i.d. x .07” xsect 249-7816-901 1
Pinch roller assembly 280-3020-901 1
Pinch roller, .188” i.d., .5” o.d., .5” t. 280-3005-901 1
Platen cover plate, 2500 636-0063-001 1
Print head, thermal 665-0028-001 1
Retaining ring, beam seal 265-0014-901 2
Screw, 2–56 x 3/16”, cap head 220-2187-001 5
Screw, 4–40 x 1/4”, cap head 220-0119-911 5