User manual

Introduction
1-8 3/97 ProMaster 2500 User Manual
.
Label Application Area
—The portion of the labeler where a printed
label is applied to the device.
Track Height Adjustment
—A hex screw allows the operator to adjust
the height of the track section to match the height of the input and output
tubes (see Figure 1-7).
Optics
—These emitter-collector pairs detect passing devices as they
travel through the system. The 2500 uses the optics to keep track of
devices entering from the input, count devices passing into the output
tubes, detect device jams if they occur, and perform other operations. A
special optic pair on the labeler (called the ADC optic) is used to sense the
location of the labels on the roll.
Figure 1-6
Dot Matrix Labeler Component Identification Drawing
1770-2
LABELING STATION
PRINT HEAD
SPRING CLIP
(1 of 2)
RIBBON
ADVANCE
KNOB
RIBBON
CASSETTE
PRESS BEARINGS
PLATEN
APPLICATION PLATE (Raised)
LABEL DRIVER ROLLER
PINCH ROLLER 2
PINCH ROLLER 1
LABEL ADVANCE
KNOB
LABEL REEL COVER
LABEL
SENSING
OPTIC
ADC OPTIC (1 of 2)