User manual

Troubleshooting
6-22 ProMaster 2500 User Manual
Figure 6-7
The Beam Does Not Deliver the Device Correctly (page numbers are in parentheses)
Does
beam release
devices?
Does the
device arrive at the
output track?
Does
beam lower to
output track
?
Does an
object block
beam?
Do
devices
move down
track?
Do devices
slide into output
tubes?
End
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
Clear the beam's vertical path
Yes
No
Check high air pressure (2-7)
Check vacuum generator (B-2)
Clean & chalk chuck tip (5-56)
Adjust track width (4-12)
Jog chuck position over track using
2500 keyboard arrow keys
Perform output track funnel
adjustment (5-64)
Adjust track air (4-38)
Check output orbital motor (5-40)
Check devices for label residue
Check for mechanical obstructions
Check +90V beam voltage (5-13)
Check flex coupler (7-21)
Clean & lubricate lead screw (5-63)
Reduce beam motor speed (B-3)
Check wiring & connectors
Check low pressure air (2-7)
Check beam up/down solenoid (5-38)
Check beam down optic test (5-32)
Clean & lubricate beam shafts (5-63)
Check wiring & connectors
Ensure that output tubes are correct
size, undamaged, & oriented correctly
Adjust track height (5-64)
Check devices for label residue
Start
Go to
Start