User manual

Troubleshooting
6-20 ProMaster 2500 User Manual
Figure 6-6 (continued)
Label Application Problems, Dot Matrix Printer (page numbers are in parentheses)
Does
part of label extend
over edge of
device?
Does beam
hold device during
labeling?
End
No
Yes
No
Yes
Clean ADC optic hole (5-56)
Adjust ADC optic value (5-34)
Adjust advance label value (B-2)
Clean label path (5-57)
Clean pinch rollers (5-57)
Check & adjust height of application
plate (2-9)
Check label stock
Check & adjust bearing plate (2-9)
Check chuck size (2-8)
Check high air pressure setting (2-7)
Clean (5-56) or replace (4-17) chuck tip
Check vacuum sensor diagnostics (5-32)
Check vacuum filter (5-61)
Clean or replace label stock
A
Are labels
being applied
correctly?
Yes
No
Call Customer Support
Go to
Start