User manual

Troubleshooting
6-14 ProMaster 2500 User Manual
Figure 6-4
Programming Failures (page numbers are in parentheses)
Acceptable
continuity/device
insertion failure
rate?
Acceptable
program/verify
failure rate?
No
Yes
No
Yes
Try another programming module & check
alignment (4-27)
Clean programming module contacts (5-61)
Replace programming module contacts
(7-28) or block (7-36)
End
Check PE reference voltage (5-51)
Run PE self test (5-50)
Try another programming module & check
alignment (4-27)
Clean programming module contacts (5-61)
Replace programming module contacts
(7-28) or block (7-36)
Go to
Start
Start