User manual

Preventive Maintenance
ProMaster 2500 User Manual 5-55
Note: A programming module must be installed to run the programming
module/relays test. To install and clamp a programming module
a Set any programming module in the programming station.
b Put the 2500 in local mode and start the Optic diagnostics test (see
page 5-32).
c Press
C
to toggle the programming module clamps closed.
d Run the programming electronics self tests. When the testing is
complete, press
C
to open the clamps, and remove the module.
9. Mass Storage Module
10.
Pin drivers
(on the pin driver boards)
Note: All of the installed programming hardware must pass self-test before any
other operations can take place. If any component has failed, contact
Customer Support at the number listed in the Preface.
Returning to the TaskLink
Screen
When the self-test has been completed, press
Alt
+
F1
to return to the
TaskLink main screen.
Preventive Maintenance Procedures For Operators
This section provides the ProMaster 2500 operator with a guideline for
routine preventive maintenance. By following these procedures for
cleaning each of the components along the device path, you can ensure
that the 2500 will continue to function properly. Maintenance at the
operator level is limited to the adjustment or cleaning of each of the listed
components.
Note: Maintenance intervals are based on operation of the ProMaster 2500 for
40 hours per week with a throughput of 40,000 devices per month.
To clean the 2500, you will need the following items:
• Lint-free cloth
• TriFlow
®
lubricant
•DeoxIT
™
Pen
• Solvent that has been approved for use by your company
• All-purpose spray cleaner
•Isopropyl alcohol
•Cotton swabs
• Compressed air
Note: These procedures recommend cleaning printer parts with a mild cleaning
solvent (such as isopropyl alcohol). Be sure to choose a solvent that has
been approved for use by your company.