User manual

Preventive Maintenance
5-44 ProMaster 2500 User Manual
To select a custom device for which you determine the length, move the
cursor to CUSTOM, and press
ENTER
. The 2500 displays:
Type the length of your device in inches, up to three decimal places and
under 2.250 inches. Press
ENTER
. If you type an invalid number, the
2500 displays:
Type a valid number and press
ENTER
.
Type Size
After you have selected an existing device or entered a valid length for
your custom device, the 2500 displays:
“S” indicates a short font, which allows more lines to be printed on the
labels. Select the font you want and press
ENTER
.
Device Orientation in
Input Tube
The 2500 displays:
Move the pin 1 icon (using the arrow keys) to match the position of pin 1
on the device in the input tube. We recommend the following settings:
• For square PLCC devices, orient pin 1 toward the back of the 2500.
• For 32-pin PLCC, all DIP, and all SOIC devices, orient pin 1 toward
the right (when standing in front of the 2500).
CAUTION: Be sure the device orientation in the display is the same as in
the input track. If it is not, during operation the device may
be inserted incorrectly into the programming module,
possibly damaging the device or module.
Press
ENTER
after you have made your selection.
PROGRAM/TEST LABEL TEMPORARY FILE
ENTER PART LENGTH: _
EXAMPLE: 1.234 OR .28 OR 1
PROGRAM/TEST LABEL TEMPORARY FILE
ENTER PART LENGTH: _
LENGTH CAN NOT EXCEED 2.250
PRINT LABEL TEMPORARY FILE
AUTO-SEL 26 CPI 26 CPI S 20 CPI
18 CPI 16 CPI T 12 CPI T
MOVE TO SELECTION THEN PRESS ENTER
1 <------- TEMPORARY FILE
SELECT POSITION OF PIN 1
AS IT COMES OUT OF THE TUBE.
USE ARROW KEYS THEN PRESS ENTER.