User manual

Preventive Maintenance
5-32 ProMaster 2500 User Manual
Optic Test
The optic test verifies that the optics and microswitches are working
correctly. To access the optic test, press
1
from the Diagnostics menu. The
2500 displays:
where ADC represents the value when the label or liner is present, VAC
represents the amount of beam vacuum, ENC is the traverse beam motor
encoder position, U15 REV X.XX and U43 REV X.XX represents the
version numbers of the 2500 firmware.
The numbers on the second line of the display represent optic or
switches, either blocked (0) or unblocked (1). Optic and switch
identification is shown in the table below; their locations are shown in
Figure 5-12.
To test the optics, follow the procedure below for each test.
1. Block the optic in the track with an opaque object.
2. Insert a tube in each input and output bin.
3. Slowly move the beam to the limit of its travel.
4. Gently push down on the beam head.
As the optic changes from unblocked (1) to blocked (0), you should hear a
beep tone as the corresponding optic value on the display changes from
(1) to (0). If an optic is not functioning properly, no tone is audible and
the display does not change.
CAUTION: Some optics are very close to each other. Therefore, to avoid
incorrect results, make sure the opaque object blocks only the
optic you want to test.
OPTIC TEST - ADC = 200 - VAC = XX
11100000001111101111111100 ENC = 13107
| | | | | U15 REV X.XX
5 10 15 20 25 U43 REV X.XX
Test Function Test Function
1 Device out of input tube 16 Output track motor CAL
2 Device detect 17 Beam reference position
3 Beam down 18 Out of labels detect
4 Beam up 19 Input tube detect
5 Unused 20 Output tube 1 detect
6 Unused 21 Output tube 2 detect
7 Unused 22 Front prog. module clamp
8 Unused 23 Rear prog. module clamp
9Unused 24Hood up
10 Unused 25 Main plate up
11 Device release, track 1 (Dot matrix printer)/
12 Device at output tube 1 End of ribbon (Thermal printer)
13 Device release, track 2 26 Unused (Dot matrix printer)/
14 Device at output tube 2 Ribbon pinch roller open
15 Input track motor CAL (Thermal printer)