User manual

Operation

ProMaster 2500 User Manual 4-31

4. Press

START

. The beam rotates the device 90

and moves it over the

programming module. Push the beam down manually (on either side

of the beam limit bar), and ensure that the device moves into the

center of the programming module’s block.

When the alignment is correct, press and hold

on the 2500

keyboard to check the device’s insertion.

Repeat steps 1 through 4 until the device moves into the center of the

programming module and does not rub one set of contacts more than

another.

5. When the alignment is correct, press

START

to continue running the

Task.

Figure 4-25

Device too Close to the Front

Figure 4-26

Device too Close to the Back

If the device was too close to the FRONT, move the beam to the RIGHT.

1860-2

FRONT

If the device was too close to the BACK, move the beam to the LEFT.

1861-2

BACK