User manual

Tasks and Kits
ProMaster 2500 User Manual 3-31
3.
Multiple User/Password Mode
—In this mode, each user has a
password and must enter it before TaskLink will display the main
screen. Users are assigned an authorization level as either an
administrator or operator (see Figure 3-20).
Depending on the security level selected, you can configure TaskLink to
require operators and administrators to enter their user name and
password before the main screen is displayed (see Figure 3-20). Users
who have been authorized as operators are restricted to the operator
mode and blocked from all administrator mode commands.
The default operator mode password is
password
. Each operator may
create a unique password to replace this default, and can change it by
selecting the
Change Password
pushbutton from the login dialog box
(see Figure 3-20). Screen prompts guide user through the process.
If an operator forgets a password, the system administrator must remove
that operator’s name from the list of users and reenter it. This allows the
operator to start over using the default password.
Note: If no one knows the correct password to use to enter a mode, call Customer
Support for assistance.
Administrators who successfully enter their user names and passwords
can access both operator and administrator modes. Press
F10
to switch
between these modes of operation (when a security level is selected,
F10
does not switch between modes). Each time you try to reenter
administrator mode from the operator screen, TaskLink prompts you to
enter the administrator password.
When security level 2 or 3 is selected, a password is required to gain
access to the
Security Setup
dialog box. Figure 3-19 shows
access-
password
as an example of a password that must be entered before an
administrator can access this dialog box.
Figure 3-20
Password Screen for System
Operators