User manual

Tasks and Kits
ProMaster 2500 User Manual 3-27
Note: To enable printing a serial number on a label, enter two or more
consecutive percent signs (%) in the text field. You must enter one
percent sign for each digit specified with the
serializ.exe
length (–l)
command line parameter.
Restore Defaults
Selecting this command directs the 2500 to restore its programming
parameters to their original defaults (such as a two pass verify, I/O
address = FFFFFFFF, Security option = 0, and others).
Data and Program
Pull-down Menus
The commands listed on these two menus allow you to select the
individual parameters needed to process devices. These are the same
commands listed in the Edit Task dialog box used to create a Task. These
individual commands are primarily used during troubleshooting and
allow you to quickly change one or two parameters and run a test
without having to create and edit a new Task for each test cycle.
TaskLink’s menus and dialog boxes refer to a file stored on one of the
internal drives (MSM or floppy) as a
Programmer Disk File.
Utilities Pull-down
Menu
Several commands available on the Utilities pull-down menu are used to
perform special operations. The specific commands and their functions
on the 2500 are described below.
–s
Sumcheck calculation flag.
Used to provide a new sumcheck for display on the
TaskLink screen as new serial numbers are generated.
This does not affect device data.
–t
Label text format.
Defines how the serial number will be printed on the
label. The options are either decimal or hexadecimal.
–td = decimal
–th = hexadecimal
Default:
Decimal (–td)
–w
Warning limit.
Sets a warning level before the serial number limit is
reached when an ending serial number is specified. If the
current serial number is within the ending serial number,
minus the warning limit, TaskLink displays a warning
message.
Default:
Zero
Parameter Description