User manual

User’s Manual
ECM-LX800 User’s Manual
51
Item Description
Enabled Enable cache
Disabled Disable cache
3.5.2.4 Quick Power On Self Test
This category speeds up Power On Self Test (POST) after you power up the computer. If it
is set to Enable, BIOS will shorten or skip some check items during POST.
Item Description
Enabled Enable quick POST
Disabled Normal POST
3.5.2.5 First/Second/Third/Other Boot Device
The BIOS attempts to load the operating system from the devices in the sequence selected
in these items.
Item Description
Floppy Floppy Device
LS120 LS120 Device
Hard Disk Hard Disk Device
CDROM CDROM Device
USB-FDD USB Floppy Device
USB-ZIP USB ZIP Device
USB-CDROM
USB CDROM Device
Legacy LAN Network Device
Disabled Disabled any boot device
3.5.2.6 Swap Floppy Drive
While system has two floppy drivers installed, this item will be affected. This function is to
assign physical drive B to logical drive A.
Item Description
Enabled Assign physical drive B to logical drive A
Disabled No change
3.5.2.7 Boot up Floppy Seek
The system will detect and verify operation of the floppy drive type.
Item Description
Enabled Enable the detection for floppy drive
Disabled Disable the detection for floppy drive
3.5.2.8 Boot Up NumLock Status
Select power on state for NumLock.
Item Description
Enabled Enable NumLock
Disabled Disable NumLock
3.5.2.9 Gate A20 Option
Select if chipset or keyboard controller should control Gate A20.
Item Description
Normal A pin in the keyboard controller controls Gate A20
Fast Lets chipset control Gate A20
3.5.2.10 Typematic Rate Setting
Key strokes repeat at a rate determined by the keyboard controller. When enabled, the
typematic rate and typematic delay can be selected.
Item Description
Enabled Enable typematic rate/delay setting