Specifications

DIGITAL-LOGIC AG Geode LX800 Manual V1.1C
Driver, Software & BIOS Information
52
Checkpoint Description Type
0B0h Starting memory test Info
0B1h Reading 64 bytes from memory Info
0B2h Writing 64 bytes to memory Info
0B3h Read and compare 64 bytes of memory Info
0B4h Walk Memory by x^2 Info
0BEh Memory test passed successfully Info
0BFh Memory test failed.
Possible causes:
- Bad memory
- Bad memory timing
Error
Checkpoint Description Type
0C0h EEPROM content valid; loading settings from EEPROM to CMOS Info
0C2h Saving CMOS settings to EEPROM Info
0CEh No SYSMEM entry found.
Possible causes:
- BIOS bug
- Flash chip defective
Error
Checkpoint Description Type
0D0h Turn on SHADOW r/w for C000-EFFF Info
0D1h Search all ROM images and decompress them Info
0D2h Initialize SMM module Info
0D3h VIDEO BIOS Init - loads which ever BIOS is at C0000 Info
0D4h Initialize a LCD panel Info
0D5h Display splash screen if enabled Info
0D6h Initialize Harddisk module Info
0D7h Write enable System BIOS region and init remaining System Roms Info
0D8h Initialize Dowser module Info
0D9h Initialize a TV solution Info
0DEh Turn off SHADOW r/w for ROM'd areas Info
0DFh Loading defaults from DLAG serial eeprom Info
Checkpoint Description Type
0E1h Early setup of the CS5536 Info
0E2h Chipset init after VSA init Info
0E8h In Core Logic initialization routine Info
Checkpoint Description Type
0F0h Perform FAR jump to post entry point Info