Specifications

DIGITAL-LOGIC AG Geode LX800 Manual V1.1C
Driver, Software & BIOS Information
39
7.3.2.1. Drive Configuration
The drive configuration screen determines the setup for the Hard drives, Floppy, CD-ROM and Flash con-
figurations.
Hard Drive Configuration:
IDE BIOS Support: Allows the configuration of the IDE channel. The options are Enabled or Disabled.
80-Conductor Cable Sense: Selects the GPIO that is connected to the IDE-PDIAG sense. The
options are: GPIO 00-17; None (disabled); Force to 40pin conductor cable; or Force to
80pin conductor cable.
DMA/UDMA BIOS Support: This enables DMA/UDMA timings. The options are Enabled and
Disabled.
Max mode for Drive 1 or 2: This enables the transfer mode. The options are: Auto; PIO 0-4;
MDMA 0 or 1; and UDMA 0-4.
Floppy Configuration: Allows the Floppy to be Enabled or Disabled.
CDROM Configuration: Allows the CD-ROM to be either Enabled or Disabled.
Flash Configuration: Allows the use of a flash device over the IDE; options are Enabled or Disabled.
Chip Select 0-3:
Size: Allows the configuration of the flash chips to be Disabled or set to the sizes 8K/16B,
16K/32B, 128K/64B, 512K/128B, 4M/256B, 8M/256B or 256M/256B (in the form Mem-
orySize / I/O size).
Base: Allows the configuration of the base address. The options are PCI defaults, D2000,
D4000 or D6000.
Type: Allows the selection of the flash memory type. The options are NOR Mem, or NAND I/O.