Specifications

TME-104-CLR-LX800-R1V3.doc Rev. 1.3 30(53)
3.18 Supervisory
The Cool LiteRunner-LX800 provides a 25-pin Supervisory Connector on its bottom side.
The table below shows the assignment of the different signals.
Connector type
DF14 25 pin header 1.25 mm, single row
Pin Signal Pin Signal
1 5V / 10mA 2 3,3V / 15mA
3 GPIO30
1
4 GPIO31
1
5 GPIO32
1
6 GPIO33
1
7 GPIO34
1
8 GPIO35
1
9 GPIO36
1
10 GPIO37
1
11 Suspend-LED² 12 Live-LED²
13 PME#³ 14 ETH1 100MBit-LED²
15 ETH1 LINK/ACT² 16 Infrared-Send
17 Infrared-Receive 18 I
2
C_CLK
19 I
2
C_DATA 20 IDE_LED#²
21 RS485 TX+ 22 RS485 TX-
23 RS485 RX+ 24 RS485 RX-
25 GND
Notes:
(1)
See chapter 4.2 about GPIO programming
(2)
Connect cathode of LED to this pin. An external resistor is required.
(3)
Power Management Signal