Specifications

TME-104-CLR-LX800-R1V3.doc Rev. 1.3 29(53)
3.16 External Power-Button
The Power-Button signal is located on the IDC10 Header PS/2. To power up/down the board the
signal Power-Button must be pulled to GND.
Connector type
IDC10 pin header 2.54 mm
Pin Signal Pin Signal
1 Speaker 2 Mouse Clock
3 Reset-In 4 Mouse Data
5 KB Data 6 KB Clock
7 GND 8 +5 Volt Standby
9 Ext. Battery 10 Power Button
3.17 Reset-In Signal
The "Reset-In" signal is located on the IDC10 Header PS/2. To reset the board, the signal "Reset-In"
must be pulled to GND.
Connector type IDC10 pin header 2.54 mm
Pin Signal Pin Signal
1 Speaker 2 Mouse Clock
3 Reset-In 4 Mouse Data
5 KB Data 6 KB Clock
7 GND 8 +5 Volt Standby
9 Ext. Battery 10 Power Button