Specifications

TME-104-CLR-LX800-R1V3.doc Rev. 1.3 27(53)
3.12 Parallel Port LPT1
The parallel port is located on an IDC26 header. An adapter cable with a standard DSUB-25 female
connector is available.
The parallel port is programmable in BIOS.
Entering Motherboard Device Configuration Æ Serial and Parallel Device Configurations,
configuration of LPT1 is accessible.
LPT1 Parameter Possible Settings
Base Address Disabled, 0x378
0x3BC and 0x278 are not recommended, because of a possible
conflict with the PCI to ISA Bridge
Mode Compatible, PS/2 Bi-directional, EPP 1.7, EPP 1.9
IRQ Disabled, IRQ 5, IRQ 7, IRQ 9, IRQ 10, IRQ 11
DMA None, Channel 1, Channel 3
LPT1 Connector
Connector type IDC26 pin header 2.54 mm
Pin Signal Pin Signal
1 Strobe 2 Auto LF
3 Data0 4 Error
5 Data1 6 Init
7 Data2 8 Select In
9 Data3 10 GND
11 Data4 12 GND
13 Data5 14 GND
15 Data6 16 GND
17 Data7 18 GND
19 ACK 20 GND
21 Busy 22 GND
23 Paper End 24 GND
25 Select 26 +5V Standby