Specifications

TME-104-CLR-LX800-R1V3.doc Rev. 1.3 18(53)

Display Voltage Jumpers

Jumper LVDS and Backlight

Connector type

IDC6 jumper 2.00 mm.

Use a 2 mm jumper between 1-3 or 3-5 to select the backlight voltage.

Use a 2 mm jumper between 2-4 or 4-6 to select the display voltage.

Signal Pin

Signal

1 +12 volts 2 +5 volts

3 Backlight voltage 4 Display voltage

5 + 5 volts 6 +3.3 volts

Backlight

Jumper 1-3 3-5

Power supply +12V +5V

LVDS

Jumper 2-4 4-6

Power supply +5V +3.3V

Note An arrow marks Pin 1

3.4 Compact Flash Socket

On the bottom side of the board a compact flash socket is located that allows the use of compact

flash cards instead of a hard disk. This socket is connected to the chipset's EIDE port. As default it is

defined as Master. Master/Slave selection can be done in BIOS.

Compact flash cards are available as solid-state disks up to several Gbytes.

With the supported UDMA-4 mode and the latest CF cards there are data rates up to 40MByte/s

possible.

default

er settin