Specifications

TME-EPIC-HURLX-R3V5.docx
Rev 3.5
Page 13 of 49
Flat Panel and LVDS Configuration
Flat panel and LVDS have the same display options as shown in the table:
Setting Possible Values
Flat Panel Type TFT, LVDS
Resolution 320x240, 640x480, 800x600, 1024x768, 1152x864,
1280x1024, 1600x1200
Data Bus Type 9-24 Bits, 1ppc
Refresh Rate 60 Hz
HSYNC Polarity High, Low
VSYNC Polarity High, Low
LP Active Period Active Only à only active during SYNC
Free Running à always active
SHFCLK Active Period Active Only à only active during SYNC
Free Running à always active
To ease usage of these displays it’s possible to select the display and backlight supply voltages with the on-board
voltage selector jumpers. (Jumper J29, see below)
Flat Panel Connector
Connector J2
Connector type: IDC30 pin header 2.00 mm
Matching connector: IDC30 pin female connector 2.00 mm
Pin Signal Pin Signal
1 GND 2 FPCLK
3 HSYNC 4 VSYNC
5 GND 6 R0 (LSB Red)
7
R1
8
R2
9
R3
10
R4
11
R5 (MSB Red)
12
GND
13
G0 (LSB Green)
14
G1
15
G2
16
G3
17
G4
18
G5 (MSB Green)
19
GND
20
B0 (LSB Blue)
21
B1
22
B2
23
B3
24
B4
25
B5 (MSB Blue)
26
GND
27
EN
28
VLCD-SW
29
VLCD-SW
30
GND