Specifications

TME-EPIC-HURLX-R3V5.docx
Rev 3.5
Page 5 of 49
MTBF
MTBF at 25°C 248.283 hours
In order to perform a failure rate assessment, several assumptions have to be made to minimize the complexity of
the analysis.
Basis for the calculation was „Parts-Stress" method according to MIL-HDBK-217 F Notice 2. Although this
method requires stress values for all components, mean stress values have been used.
Environmental factor „Ground Benign" according to MIL-HDBK-217 has been used as well as an environmental
temperature of 25 °C.
Failure rate of mechanical components (screws, chassis, etc) is negligible.
The detailed analysis report is available on request.
Mechanical
Dimensions (L x W) 165 mm x 115 mm
Height max. 40 mm on topside above PCB
max. 12 mm on bottom side above PCB
Weight 275 g (incl. RAM)
Mounting 4 mounting holes for PCB
4 mounting holes for PC104/PC104+ extension cards
Note:
It is strongly recommend using plastic spacers instead of metal spacers to mount
the board. With metal spacers, there is a possible danger to create a short circuit
with the components located around the mounting holes.
This can damage the board!