Specifications

TME-104P-CSR-LX800-R1V11.doc Rev 1.11 29 (50)
PC/104 Plus Bus Connector
Pin A B C D
1 GND Reserved +5 Volt AD00
2 VI/O AD02 AD01 +5 Volt
3 AD05 GND AD04 AD03
4 C/BE0 AD07 GND AD06
5 GND AD09 AD08 GND
6 AD11 VI/O AD10 M66EN
7 AD14 AD13 GND AD12
8 n.c. C/BE1 AD15 n.c.
9 SERR GND SB0 PAR
10 GND PERR n.c. SDONE
11 STOP n.c. LOCK GND
12 n.c. TRDY GND DEVSEL
13 FRAME GND IRDY n.c.
14 GND AD16 n.c. C/BE2
15 AD18 n.c. AD17 GND
16 AD21 AD20 GND AD19
17 n.c. AD23 AD22 n.c.
18 IDSEL0 GND IDSEL1 IDSEL2
19 AD24 C/BE3 VI/O IDSEL3
20 GND AD26 AD25 GND
21 AD29 +5 Volt AD28 AD27
22 +5 Volt AD30 GND AD31
23 REQ0 GND REQ1 VI/O
24 GND REQ2 +5 Volt GNT0
25 GNT1 VI/O GNT2 GND
26 +5 Volt CLK0 GND CKL1
27 CLK2 +5 Volt CLK3 GND
28 GND INTD +5 Volt RST
29 +12 Volt INTA INTB INTC
30 -12 Volt REQ3 GNT3 GND
Note:
All VI/O pins are connected to +3,3 V at default.
The voltages +5 V, +12 V and -12 V are not generated by the onboard
power-supply but they are routed from the Power Supply Connector.
The maximum current is limited depending on voltage:
+12 V < 1 A; -12 V < 0,3 A; +5 V < 8 A
One pin can be used for 1 A at maximum.
X17