Specifications

TME-104P-CSR-LX800-R1V11.doc Rev 1.11 26 (50)
3.12 Speaker
The speaker signal is located on the IDC10 Header PS/2. A standard PC
Speaker can be connected between the signal SPEAKER and VCCKB.
Connector type: IDC10 pin header 2.54 mm
Matching connector:
IDC10 pin female connector 2.54 mm
3.13 External Power-Button
The Power-Button signal is located on the IDC10 Header PS/2. To power up/down the board the signal Power-
Button must be pulled to GND. It is not available in standard configuration.
Connector type: IDC10 pin header 2.54 mm
Matching connector: IDC10 pin female connector 2.54 mm
Pin
Signal
Pin
Signal
1 Speaker 2 Mouse Clock
3 Reset-In 4 Mouse Data
5 KB Data 6 KB Clock
7 GND 8 +5 Volt Switched
9 Ext. Battery 10 Power Button
12
0.5 A is the maximum current for each pin; power supply will be switched off in standby mode
Pin
Signal
Pin
Signal
1 Speaker 2 Mouse Clock
3 Reset-In 4 Mouse Data
5 KB Data 6 KB Clock
7 GND 8 +5 Volt Switched
12
9 Ext. Battery 10 Power Button (default)/
Reset-In
X16
X16