Specifications

TME-104P-CSR-LX800-R1V11.doc Rev 1.11 19 (50)
3.6 On Board Power Supply
The on board power controllers generate all necessary voltages from the single supply voltage
of 5 Volt. The generated 3.3 Volt is available at Backlight- and LVDS- connector.
Note
This 3.3 V cannot be used to supply external electronic devices with high power
consumption like other PC/104 boards or displays.
Power Connector
Connector type: JST B15B-EH-A 15 pin
Matching connector: JST EHR-15 15 pin female connector
Pin
Signal (standard)
Signal (5V only)
1 +5 V +5V
2 GND GND
3 +5V +5V
4 GND GND
5 +5V +5V
6 n.c. n.c.
7 GND GND
8 GND GND
9 n.c. n.c
10 n.c. n.c
11 GND GND
12 +12V n.c
13 +12V
n.c
14 GND GND
15 -12V n.c
Note
The default cable adapter supports the connection of ±12V power supply.
That pins are routed to the PC/104- , PC/104-plus bus as well as the backlight port.
If the 5 V only power supply is required leave these pins open.
The board can be supplied over the 5 V pins of the PC/104- or PC/104 plus bus too.
X19