User manual

Publication AG-UM008C-EN-P - February 2005
2-20 Configuring Enhanced PLC-5 Processors
Configuring the Processor
as a Station on a
Point-to-Point Link
To configure the processor as a station on a point-to-point link, place
the processor in program mode and follow the steps below using your
programming software:
Use Table 2.6. to help you understand the screen parameters you
need to specify on the Channel Configuration screen.
Use Worksheet 2.4 (page D-8) for an example configuration and to
record your station’s configuration.
1. Double-click on the Channel
Configuration file to bring up
the Edit Channel Properties
interface.
2. On the Channel 0 tab, choose
System (Point-to-Point) for
your Communication Mode.
3. Configure the Serial Port
parameters according to
Table 2.6.
4.
C
onfigure the
O
ptions
parameters according to
Table 2.6.
5. When all parameters are set,
click OK.