User manual

1 Publication AG-UM008C-EN-P - February 2005

Chapter

Remotely Program Allen-Bradley Processors

Over a Telemetry Network

Chapter Objectives

This chapter helps you set up and configure RSLogix programming

terminals on Ethernet to program remote PLC-5, SLC 500, MicroLogix,

and Logix processors over a point-to-multipoint telemetry network.

Connecting RSLogix programming software to the remote stations

over the telemetry network helps you do the following without having

to go to the remote site:

• monitor the online data table

• upload, download, and edit the ladder logic program

• troubleshoot the system

You can remotely connect to your processors while normal telemetry

system data acquisition and control functions occur concurrently.

For information about See page

remote programming via RSLinx Classic Gateway 11-2

remote programming via SLC 5/05 Ethernet to DF1 Passthru 11-4

remote programming via Logix Ethernet/IP to DF1 Bridge 11-7