User manual

Publication AG-UM008C-EN-P - February 2005

5-4 Configuring SLC 500 Processors with 1747-KE Interface Modules

Configuring the 1747-KE

Interface Module

To configure the interface module with an ASCII terminal:

• prepare to configure the driver

• configure the DF1 protocol driver, and

• save the configuration

Prepare to Configure the Driver

1. Connect an ASCII terminal or personal computer running

terminal emulation software to the interface module’s CONFIG

port.

2. Turn on power to the chassis containing the interface module.

3. Run the ASCII terminal emulation software, and configure the

software to match the default CONFIG port parameters, which

are the following:

4. Configure the DF1 port as shown in Figure 5.3.

DH-485/RS-232C

ACT

485

CFG

DF1

Fault

BA LOW

H/D

F/D

41200

ASCII

9-pin female 9-pin female

Parameter Selections

Baud rate 1200

Bits per character 8

Parity none

Stop bits one