User guide

DATA-LINC GROUP
PN 161-09981-002C
Product User Guide
FCC Notification
This device complies with part 15 of the FCC rules. Operation is subject to the following conditions:
1) This device may not cause harmful interference and
2) This device must accept any interference received, including interference that may cause undesired operation.
The device must be operated as supplied by Data-Linc Group. Any changes or modifications made to the device without the
express written approval of Data-Linc Group may void the user’s authority to operate the device.
Caution: This radio transmitter module has maximum transmitted output power of 500 mW. It is recommended that the
transmit antenna be kept at least 23 cm away from nearby persons to satisfy FCC RF exposure requirements.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
an industrial installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
Note: Whenever any Data-Linc Group series modem is placed inside an enclosure, a label must be placed on the
outside of that enclosure which includes the modem’s FCC ID.
The following types of antennas are approved for use with Data-Linc Group’s series modems. Consult Data-Linc Group Sales
for particular model numbers. Only Data-Linc Group approved antennas can be legally used with this Data-Linc Group
equipment. Antennas are available both as individual items or as part of a pre-made kit that includes cables.
2.4GHz Omni Directional Antenna 2.4GHz Directional Antenna
Note: The antenna used for this device must be professionally installed on a fixed-mounted permanent outdoor
structure for satisfying RF exposure requirements, including antenna co-location requirements of 1.1307(b)(3).
niaGBd5
niaGBd0
niaGBd6.6