User guide

DATA-LINC GROUP

PN 161-09889-001B

rev 3/2005 ver 6.33c

PLR580D / DA User Guide

Changing System or Radio Configurations

To access the system or radio setups the user must remove all connectors from the PLR580D or PLR580DA, then

remove the cover and change the jumpers at location P1 and P2, and add a serial data cable (SRM6200E-SLC),

supplied by Data-Linc Group, to connector P3. These jumper settings must be returned to the RUN/RF settings after

reconfiguring the system or the radio or the units will not operate. See layout drawing.

There are 4 configurations of the jumpers.

1. RUN / RF Normal PLR580 operating mode

2. CONFIG / RF Serial port P3 to PC (computer) to access the radio parameters

3. CONFIG / PIC To reprogram the system configuration setup memory

4. RUN / EXT Factory use only - do not use

If changing the system configuration go to Appendix B.

If changing the radio parameters go to Appendix C.

Figure 9: Layout Drawing