User guide
43
Wireless I/O Extender User’s Guide
PN 161-09981-007A
January 2010
•Rcv Options (0 – 9, A - F) / (0 – 15)
The channel to listen to.
•Xmit Options (0 – 9, A - F) / (0 – 15)
The channel to use for transmitting.
The default is disable, which is a setting for both Rcv and Xmit of F.
The master using this mode should have a setting for both Rcv and Xmit of 0.
Note: The Subnet ID only works in a multipoint system using Network ID addressing.
Note: The transmit (Xmit) Subnet ID parameter is only used for multipoint repeaters.
Note: A Master will always transmit and receive on 0 and should be set to Rcv 0 and Xmit 0, which is roaming
mode.
Sample picture of using network ID:
Note: Options in Blue are SRM models only
(D) Radio ID
Sets an arbitrary, user selectable, 4-digit number, which identies the transceiver in diagnostics mode.
•Set to the arbitrary number to use as reference in diagnostics mode.
Note: Once this option is changed it cannot be changed back to “not set”; this does not affect the operation of the
unit in any way.
(E) Local Access
These settings are typically not used. Contact Data-Linc Group for further information.
Note: This feature is only available with rmware versions 2.54 and 3.54 or higher.
(G) Radio Name
Sets a unique radio name up to 20 characters in length.
Master
Repeater /
Remote 0
Remote 1
Network ID: 100
SubNet ID TX: 0 RX: 0 (Roaming)
Network ID: 100
SubNet ID TX: 1 RX: 0
Network ID: 100
SubNet ID TX: F RX: 1
Note “TX:” is ignored on
Remote only