User guide

18
PN 161-09981-007A
January 2010
Wireless I/O Extender Users Guide
Point-to-Point Network (Using Call Book)
Enter the Call Book number of the Master and Remote into the elds under “Using Call Book”.
Program the Master
•Make sure “Master” is selected from “Modem Type To Congure”.
•Press the “Program Radio” Button.
•Press the SW1 on the Wireless I/O Extender PCB to put the radio into Conguration mode and program the unit.
•When completed remove power, programming cable, and return the switches to the Run Mode.
Program the Remote
•Make sure “Remote calls Master” is selected from “Modem Type To Congure”.
•Press the “Program Radio” Button.
•Press the SW1 on the Wireless I/O Extender PCB to put the radio into Conguration mode and program the unit.
•When completed remove power, programming cable, and return the switches to the Run Mode.
Point-to-Multipoint Network (Using Network ID)
Enter a Network ID number into the eld “Using Network ID”.
Program the Master
•Make sure “Master” is selected from “Modem Type To Congure”.
•Press the “Program Radio” Button.
•Press the SW1 on the Wireless I/O Extender PCB to put the radio into Conguration mode and program the unit.
•When completed remove power, programming cable, and return the switches to the Run Mode.
Program the Remote
•Make sure “Remote calls Master” is selected from “Modem Type To Congure”.
•Press the “Program Radio” Button.
•Press the SW1 on the Wireless I/O Extender PCB to put the radio into Conguration mode and program the unit.
•When completed remove power, programming cable, and return the switches to the Run Mode.
Point-to-Multipoint Network (Using Call Book)
Enter the Call Book number of the Master (and Repeater) into the elds under “Using Call Book”.
Program the Master
•Make sure “Master” is selected from “Modem Type To Congure”.
•Press the “Program Radio” Button.
•Press the SW1 on the Wireless I/O Extender PCB to put the radio into conguration mode and program the unit.
•When completed remove power, programming cable, and return the switches to the Run Mode.
Program the Remote
•Make sure “Remote calls Master” is selected from “Modem Type To Congure”.
•Press the “Program Radio” Button.
•Press the SW1 on the Wireless I/O Extender PCB to put the radio into conguration mode
and program the unit.
•When completed remove power, programming cable, and return the switches to the Run Mode.