User guide

Wireless I/O Extender User’s Guide

PN 161-09981-007A

January 2010

Change Radio Configuration

Remove all the connectors from the Wireless I/O Extender.

Remove the 4 screws on the top to remove the cover.

Connect the programming serial data cable from PC to Mini-Din connector (P3).

Note: This cable should be supplied one per system, available from Data-Linc Group.

Set the switches to “Radio Cong” (5&6 ON, 1,2,3&4 OFF).

Select the “Radio Conguration” Tab.

Note: Change the Frequency if another system will be in the area to help reduce noise to the other system.

Choose the “Network type”:

•Point to Point – For a Master and one Remote. – See Point-to-point Network below.

•Point to Multipoint - For a Master and 1-8 Remotes.

•Select Network ID or Call Book – see Point-to-Multipoint Network below.