User guide

16
PN 161-09981-007A
January 2010
Wireless I/O Extender User’s Guide
Select the product model “PLR580DA or DDAA1000”(Analog Channels) or “PLR580D or DD1000” (Discrete Only).
Select the operation mode “Master” or “Remote”.
Select the baud rate (default is 19200, the radio baud rate must match this).
Select the fail states for the channels and the alarm function.
Programming a Master
•Select the number of remotes in the system.
•Select the number of analog channels for each remote in the system.
Programming a Remote
•Select the address number of the remote in the system.
•Select the number of analog channels for that remote (this should be done if the master was already
programmed and the software wasn’t closed).
Select the Comm Port number used on the PC.
Press the “Program Eeprom” button.
Follow the prompt and apply power to the unit.
The microprocessor is now programmed.
Note: To program the radio, skip to “Radio Conguration” section
Remove the power and programming cable.
Set the switches to the “Run Mode” (1&2 ON, 3,4,5&6 OFF).
Replace the cover.
Reconnect the connectors.