User's Guide

42 Part #880-0325-01 Rev. A
AlarmView™ System User’s Guide
3. Press and hold the transmitter On/Off button until a “Pro-
gramming OK” confirmation message is received at the
pager (approximately 5 seconds).
Bed: 1234
Programming OK
All Pagers
Setting Reminder Page Delay
If an alarm condition continues or has not been silenced at the
monitor, the transmitter will follow up with a Reminder Page
sent once to all pagers in the system.
The format will be the same as the initial page, except that the
word “Rem” will be added to the first line. Current patient data at
the time the Reminder Page was transmitted are displayed.
Bed: 1234 REM
Test Page
SPO2: 83%
PR: 70 bpm
The Reminder Page will be sent only once. The time delay of
the reminder can be set using the programmer. Follow the next
procedure to view and change the time delay.
u The time delay interval is intended to be the same for the entire
system. When changing this value, you should program the
change into every transmitter in the system.