User's Guide
Table Of Contents
- _
- Using this Guide
- Procedures
- Warnings
- Cautions
- Notes
- For More Information
- Safety Information
- System Warnings
- Section 1: AlarmView™ System Overview
- Introduction
- AlarmView™ Transmitter
- AlarmView™ Pager
- AlarmView™ Programmer
- Section 2: AlarmView™ Transmitter Overview
- Transmitter Product Description
- Top Panel
- Antenna Connector
- On/Off Button
- Front Panel
- AC Indicator
- Transmitting Indicator
- Communications Indicator
- Infrared Port
- Rear Panel
- Monitor Input Port
- Power Input Port
- Using the Transmitter
- Transmitter Placement
- Turning Transmitter On
- Turning Transmitter Off
- Operating Transmitter On Battery Power
- Testing System Setup
- Send Test Page
- Section 3: AlarmView™ Pager Overview
- Pager Product Description
- Alarm Pages
- Alarm Page Event Levels
- Alarm Page Format
- Alarm Page Types
- Alarm Pages
- System Error Pages
- Section 4: AlarmView™ Programmer Overview
- Programmer Product Description
- Using the Programmer
- Viewing and Editing Bed Numbers
- Viewing and Editing Pager Numbers
- Viewing and Changing Bed and Pager Assignments
- Viewing Current Transmitter Assignments
- Changing Transmitter Assignments
- Assigning All Pagers from the Transmitter
- Setting Reminder Page Delay
- Section 5: Maintenance, Service, and Support
- Cleaning Procedures
- Inspection and Testing
- Electromagnetic Interference (EMI)
- Appendix A: Basic Pager Functions
- Pager On/Off
- Power On
- Power Off
- Setting the Pager Functions
- Setting Tone
- Setting Time
- Setting Date
- Adjusting Screen Contrast
- Message Mode
- Viewing Messages
- Deleting Messages
- Deleting a Single Message
- Delete All Messages at Once
- Replacing Battery
- Removing and installing the battery
- Appendix B: Basic Programmer Functions
- Safety Information
- General Precautions
- Damage Requiring Service
- Servicing
- Heat
- Water and Moisture
- Accessibility
- Internal Battery
- Rechargeable Battery Pack
- Programmer Functions
- Programmer On/Off
- Turn on Backlight
- Adjusting Screen Contrast
- Setting Date/Time
- Batteries
- Recharging Main Programmer Battery
- Replacing Programmer Backup Battery
Section 3: AlarmView
TM
Pager Overview
Part #880-0325-01 Rev. A 23
Message Description Pri
Tx Battery
Low/Shutting
Down
Transmitter operating on battery
power has depleted battery
charge and will shut down
immediately
Comm
Failure/Shutting
Down
Transmitter has not been able to
communicate with the monitor for
about an hour and is shutting
down
Sensor Disconn Sensor has become disconnected
from monitor during monitoring
ECG/RSP Cable
Dis
ECG cable has become
disconnected from monitor or
ECG leads during monitoring
ECG/RSP Lead
Off
ECG leads have become
disconnected from patient during
monitoring
ECG/RSP Noise Monitor has detected unwanted
noise in the ECG or respiration
signal
ECG/RSP Op
Fail
Monitor’s ECG/Respiration
function is non-operational
Sensor Off SPO2 Sensor has become
disconnected from the patient
during monitoring
Low Mon
Battery
Monitor’s battery is running low
(N-395 only. The other monitors
will not communicate when
running on battery.)
Low Tx Battery Transmitter
’
s battery is running
System Error Pages