User Manual

AlarmView™ System Administrator’s Manual
Part #880-0326-01 REV. 10/4/2000 Appendix C-1
RESTORING ALARMVIEW PROGRAMMER
SOFTWARE
The AlarmView programmer ships from the factory with a memory card
installed that has a backup of the AlarmView software.
The following procedure will restore the software to the factory default
state:
If both the main and the backup batteries of the Compaq
programmer have become depleted or have been removed
simultaneously, the Intouch software may not appear when both
batteries are reinstalled. Use the following procedure to restore
the Intouch program:
1. If the programmer is not already on, press the Power
button to turn it on.
2. Press the Q button on the side of the programmer.
3. Select “QUtilities.” (Your menu may look somewhat
different than the one illustrated below.)
4. Click on the CF Backup tab.
5. Click on the Restore button to access the restore
program.
6. Click on the Start button to initiate the restore process.
7. A message asks you if you are sure you want to
continue. Click Yes.
8. A warning box appears, reminding you not to try to use
the device or remove the flash card while the
programmer is being restored. Click on “OK.”
9. A status bar reporting the activity until the function is
complete (the status bar may stay on 99% for several
minutes). When the process is complete, a message
appears telling you to press the Reset button to resume
operation. Click on “OK.”
10. Press the Left-most application button to display the
Intouch 3-button screen.