User Manual

AlarmView™ System Administrator’s Manual
880-0326-01 REV. A Page 57
Programming Failed
Programmer was
unable to send
programming changes
to transmitter.
Interference or
ambient light noise.
Programmer batteries
are low.
Transmitter defective.
Programmer
defective.
Re-align ports and try
again.
Recharge programmer
batteries.
Contact Data Critical
regarding repair
and/or replacement of
transmitter or
programmer.
Unable to Access Port
Probably in Use
Programmer error. Reboot programmer
by inserting stylus in
the reset button
located on the back on
the programmer.
Contact Data Critical
regarding repair
and/or replacement of
programmer.
You must select or get
a bed number and one
or more pagers
Programmer SEND
button was pressed
before selecting a bed
number or pager
numbers.
Follow procedure to
select bed and/or
pager numbers and
tap SEND again.