User Manual

AlarmView™ System Administrator’s Manual
880-0326-01 REV. A Page 42
Changing Frequency, Baud Rate, and Global Cap Code
1. Tap the Start button and tap the AlarmView Install
Program.
2. Enter your password. The Alarms screen will be displayed.
3. Tap the Pagers tab to enter the Pager configuration screen.
Pager Configuration Screen
4. Turn on any transmitter in the system, and aim the
programmer’s infrared port directly at the infrared port on the
front of the transmitter.
5. Tap CHECK to retrieve the current system configuration
parameters.
6. a. To change the sending frequency, tap the Down Arrow in
the MHz field. The Sending frequency is the frequency
transmitted from the transmitter to the pager.
b. To change the baud rate, tap the Down Arrow in the bps
field. This programs the transmitter’s baud rate to match the
pager’s receiving baud rate.