User Manual

AlarmView™ System Administrator’s Manual
880-0326-01 REV. A Page 30
Tap the Exit button
(in upper left corner of screen) to return to
SysMgr Main Screen from submenus.
Tap the Scroll buttons
to move left and right to make tabs visible
in submenus.
Tap Down Arrow to reveal pull-down menu choices.
Changing System Parameters
AlarmView System parameters are set and transmitters are configured to
your specific site during initial system installation.
Only qualified personnel should use the AlarmView Install Program
software to view and change system configuration and parameters that
cannot be changed with the SysMgr program.
The Install Program has five main screens: Password, Alarms, Pagers,
Monitors, and Sys Inf (system information), which are used to change
the following parameters.
• Default program password (DCC)
• Bed Numbers (up to 48)
• Pager Cap Codes (up to 12)
• Alarm Pager Destinations (1, 2, or all pagers)
• Bed Number and Pager Assignments
• Transmission Frequency (MHz) and Baud Rate (bps)
• Global Pager Cap Code
• Reminder Page Delay Interval
• Survey Page Interval and Duration
!!
!!
!!
Some of the above can also be accessed and changed through
the SysMgr main program.