User's Guide

Communicating With Patient
Monitoring Equipment
Turn on the transmitter, as described above. Attach the serial cable to
the RJ-45 port. Attach the other end of the cable to the patient
monitoring equipment. The transmitter will automatically detect the
monitor (assuming it is an N-3000, N-295, or N-290). Once
communications have been established with the patient monitoring
equipment, a page will be sent to the pager indicating this, and the LED
will turn GREEN.
The communications established page will have the following data:
Bed: xxxxx
Comms OK
<Insert photo and or screen shot here>
From that point, all alarms at the patient monitoring equipment will be
sent to the pager(s), as assigned by the PDA (as described above).