User's Guide

Monitoring Device Types

The AlarmView software is currently configured to be compatible with

Nellcor Puritan Bennett Pulse Oximeters N-290, N-295, or N-3000.

Getting Started

Before turning on the transmitter, ensure that the antenna is attached to

the transmitter. The antenna is attached to the transmitter via a BNC

connector found on the back of the transmitter (directly behind the LED).

The power cable is attached on the back of the transmitter to the far

right. The unit can now be turned on by pressing the button on the top of

the transmitter.

<Insert AlarmView Transmitter Device Unit image with arrow pointing to

button here>

Survey Mode

The Survey Mode is a mode in which frequent periodic pages are sent

from the transmitter to the assigned pager(s). To begin the Survey

Mode, turn on the transmitter, as described above. The transmitter

should not be attached to any patient monitoring equipment as this point.

The LED on the front of the transmitter will be ORANGE to indicate that

the transmitter is attempting to establish communications with the patient

monitoring equipment. Press the button on the top of the transmitter,

and hold the button down for approximately 5 seconds. A numbered

“Survey Page” will be sent. Every 15 seconds, another “Survey Page”

will be sent. This will continue until one hundred pages have been sent.

To stop the survey mode before one hundred pages have been sent,

press the button on the top of the transmitter, and hold the button down

for approximately 5 seconds.