Service Manual

AlarmView™ Service and Installation Manual
Page 46
At this point, if the displayed data is correct, no changes need be
made, and the user is done. Exit the Configuration Program by
tapping the “X” in the upper right corner of the screen.
If the data needs to be changed, the Patient Bed Number can be
selected by tapping on the bed number drop down list, and
highlighting the desired bed number.
A maximum of two pagers can be selected by clicking the radio
button next to the desired pager number.
To change/view alarm severity selection or reminder page
intervals, tap the Advanced Setup Button on the upper left of the
screen. If no data has been previously downloaded, the PDA will
attempt to establish communications with the transmitter. When
the data is downloaded, the following screen will appear.