Service Manual

AlarmView™ Service and Installation Manual
Page 12
List of Components
Please check that all of the following components are present:
AlarmView Transmitter
7” Antenna
Power Cable for Transmitter
Battery for Transmitter
AlarmView Programmer
Programmer Charging Cradle
Programmer Batteries
AlarmView Pager
Pager Batteries
Serial Cable for Connection from AlarmView Transmitter to PME
Setup
Attach the antenna to the AlarmView transmitter.
Power the AlarmView transmitter.
Attach the monitor to the AlarmView transmitter.
Be sure the monitor is not running on battery.
General Warnings
Make sure that the antenna is attached to the transmitter before
attempting to send any pages. Failure to do so may cause
internal damage to the transmitter.
Be sure that the monitor has power, and is not running on
battery. A monitor on battery power does not communicate via
it’s serial port, and the transmitter will be unable to establish
communications with the monitor.
Connecting AlarmView
The AlarmView transmitter must be physically connected to the
PME via the serial cable in order for communications to exist.
Performance Verification
Performance verification is discussed below in the Quick Start
section.