Service Manual

AlarmView™ Service and Installation Manual
Page 27
v Power for all peripheral equipment is installed, tested, and
ready for use. This includes testing for proper grounding of
the power source.
v All equipment, including all peripheral devices, must be
unpacked and ready for installation. All required cables
must be identified and prepared for installation.
v Install the transmitter at the desired location.
v Connect the transmitter to the power source.
v Connect the antenna to the transmitter.
Do not turn on the unit or
attempt to transmit patient data
unless the antennas are
attached; if you do not attach
the antenna, you may damage
the radio module.