Service Manual

AlarmView™ Service and Installation Manual
Page 20
Maintenance
Service
The AlarmView™ Pager
<Insert photo and or screen shot here>
Changing the battery
The AlarmView™ Pager requires one AAA alkaline battery.
• Use only 1.5 Volt AAA alkaline battery.
• Observe proper polarity when installing battery.
• Do not dispose of battery in fire.
• Do not attempt to recharge alkaline batteries.
• Remove battery from pager if the pager will not be
used for 2 days or more.
To change the battery:
With the back of the pager facing you, carefully remove the
battery cover. Remove the old battery and throw it away. Put a
new battery in the slot Be sure that the “+” on the battery
matches up with the “+” on the pager. Put the battery cover back
on the pager. Turn the pager on to make sure the battery works.
Power
Certain pagers will chirp or display a message to tell you that the
battery will need to be replaced.
Screen
The pager screen should be protected to keep from being
scratched and broken. If the screen should become cracked or
moisture appears inside, the pager should be replaced.