User Manual

PATIENT SETTINGS
84 PatientNet Operator’s Manual, v1.04, 10001001-00X, Draft
All information contained herein is subject to the rights and restrictions on the title page.
Selecting Monitored Parameters for the Configurable Data Block
The configurable block displays up to four monitored parameters at a time. You can
change the displayed parameters at any time as a patient’s monitoring needs change.
The available parameters for each patient type are shown below.
Table 8. Available parameters for configurable data block
Patient Type Available Parameters
Ambulatory
• Heart rate
•PVC
• Battery level of transceiver
• Percent of paced beats
• Transceiver ID
• High/low heart rate limits
• Leadset (3-, 4-, 5-wire)
•ST level
Bedside Monitor
• Heart rate
•P
1
systolic/diastolic
•P
1
mean
•P
2
systolic/diastolic
•P
2
mean
•P
3
systolic/diastolic
•P
3
mean
•P
4
systolic/diastolic
•P
4
mean
•P
5
systolic/diastolic
•P
5
mean
•P
6
systolic/diastolic
•P
6
mean
• BP systolic/diastolic
• BP mean
•EtCO
2
•InCO
2
•SpO
2
• Temperature
1
• Temperature
2
• Temperature ∆
• Respiratory rate
•PVC
• Heart rate source
• RESP rate source
•Battery
• Percent of paced beats
•BP Elapsed Time
• Transceiver ID
• Cardiac Output
•Cardiac Index
• Body Surface Area
•PAWP
• High/low heart rate limits
• Device type name
•ST level
Ventilator
• Heart rate
•SpO
2
• Respiratory rate
• Inspiration: Expiration ratio
• Tidal volume
• Minute volume
• Spontaneous minute vol-
ume
• Peak inspiratory pressure
• Mean airway pressure
• Plateau pressure
• Oxygen %
•PEEP/CPAP
• Transceiver ID
• Device Type Name