User Manual

WMTS OPENNET LAN PROGRAMMING AND DIAGNOSTICS
PatientNet Administrator’s Guide, v1.04, 10001003-004, Revision B 123
All information contained herein is subject to the rights and restrictions on the title page.
Programming Ambulatory Transceivers (DT-4500)
To program the DT-4500:
1. Access the OpenNet LAN screen (page 101).
2. Click the Program AT button to open the Ambulatory Transceiver Program-
ming screen (fig. 77).
Fig. 77. Ambulatory Transceiver Programming screen
3. If the “No response from transceiver” popup appears, check the program-
ming cable connections and the transceiver battery. To re-attempt, wait until
the I/O LED on the DT-4500 stops flashing, and then select the Read TX but-
ton.
4. Click the Tx Info button to open the Transceiver Information popup (fig. 78),
which displays the current information for the attached transceiver. Click OK
to close the popup
Fig. 78. Transceiver Information popup
5. Click the Read TX button to read the currently programmed information
located on the transceiver and update the fields on the Program Transceiver
screen.