User Manual

WMTS OPENNET LAN PROGRAMMING AND DIAGNOSTICS
PatientNet Administrator’s Guide, v1.04, 10001003-004, Revision B 121
All information contained herein is subject to the rights and restrictions on the title page.
Configuring Access Point Defaults
You can configure the default settings for all Access Points in the Access Point
Default Configuration screen.
To configure Access Point defaults:
1. Access the OpenNet System Configuration screen (page 120).
2. Click the Set AP Defaults button to open the Access Point Default Configu-
ration screen (fig. 75).
Fig. 75. Access Point Default Configuration Screen
3. Click the RF Modules button to toggle the RF Module setting between 1 and
2. The RF Module setting defines the default number of RF Modules that
reside in each Access Point.
4. Click the IP Address button to open a keypad with which you can set the
default IP address for the Access Points.
5. Click the Location button to open the Location popup (see fig. 76 on page
121), which allows you to enter the default location of the Access Points.
Fig. 76. Access Point Default Location Popup
6. Click the Exit button to close the Access Point Default Configuration screen
and return to the OpenNet System Configuration screen.