User Manual

WMTS OPENNET LAN PROGRAMMING AND DIAGNOSTICS
120 PatientNet Administrator’s Guide, v1.04, 10001003-004, Revision B
All information contained herein is subject to the rights and restrictions on the title page.
Configuring the OpenNet System
You can configure the OpenNet LAN parameters that are specific to each WMTS
Central Station with the OpenNet System Configuration screen.
To configure the OpenNet system:
1. Click the System button on the OpenNet LAN screen to open the OpenNet
System Configuration screen (fig. 74).
Fig. 74. OpenNet System Configuration Screen
2. Click the IP Address button to open a keypad with which you enter the Open-
Net LAN IP address for the system.
3. Click the Subnet Mask button to open a keypad with which you can enter the
OpenNet LAN subnet mask for the system.
4. The Default Gateway button will be available in future releases.
5. The Multicast TTL button will be available in future releases.
6. Click the Set AP Defaults button to open the Access Point Default Configu-
ration screen (see “Configuring Access Point Defaults” on page 121).
7. Click the Exit button to close the OpenNet System Configuration screen and
return to the OpenNet LAN screen.